The P3443 fault code in automobiles indicates a problem with the Valve Lifter Oil Manifold Assembly. The most common symptom is the Engine Light turning on. The cause of this issue can be low oil pressure, restricted oil passage, faulty valve lifter oil manifold assembly, or a poor electrical connection.
It is important to address this issue promptly as it can lead to engine damage. The repair difficulty is moderate, and the estimated repair time is around 1.0 hour.
To fix the issue, one should visually inspect the wiring harness and connectors, check for damaged components, and look for broken, bent, pushed out, or corroded connector’s pins.
Repair Importance Level | 10.0 (Out of 10) |
Estimated Repair Time | Approximately 1.0 hour |
Repair Difficulty Level | 10.0 (Out of 10) |
P3443: Uncovering The Symptoms Of This Auto Fault Code
If you notice the Engine Light ON (or Service Engine Soon Warning Light), it could be due to the p3443 fault code. Here are the symptoms to look out for:
- The P3443 fault code in an automobile can cause several symptoms, including the engine light turning on or the service engine soon warning light appearing.
- Other symptoms may include rough idling, reduced engine power, engine misfires, and increased fuel consumption.
- Additionally, the vehicle may experience a decrease in acceleration, a loss of power while driving, and a decrease in overall performance.
- It is important to address these symptoms promptly to prevent further damage to the vehicle.
P3443: Uncovering The Culprits Behind The Fault Code
The P3443 fault code in automobiles can be caused by various factors, including low oil pressure and faulty valve lifter oil manifold assembly.
- The automobile fault code P3443 can be caused by low oil pressure.
- It can also be caused by a restricted oil passage.
- Another cause of this fault code is a faulty Valve Lifter Oil Manifold Assembly.
- An open or shorted Valve Lifter Oil Manifold Assembly harness can also trigger this code.
- A poor electrical connection in the Valve Lifter Oil Manifold Assembly circuit can also be a cause.
- Lastly, a faulty Engine Control Module (ECM) can also be a reason for the P3443 fault code.
Fix Code P3443: Simple Steps To Solve The Issue
Below are the possible fixes for the automobile fault code p3443, including inspecting wiring harness and connectors for damage.
- To fix the automobile fault code p3443, you need to check the possible causes listed above.
- Visually inspect the related wiring harness and connectors.
- Look for damaged components and check for broken, bent, pushed out, or corroded connector’s pins.
- This fix will take an estimated repair time of 1.0 hour.
P3443: Affordable Fix For Complex Auto Fault Code
The automobile fault code P3443 can be diagnosed and fixed within an estimated repair time of 1.0 hour.
The cost of repair is influenced by the hourly rate charged by the auto repair shop, which typically ranges between $75 and $150 per hour.
Therefore, the total cost of diagnosis and fixing the P3443 fault code will depend on the hourly rate charged by the auto repair shop and the estimated repair time required to fix the issue.
P3443: The Lowdown On Faulty Intake Valve Control Circuit Bank 2
The P3443 code refers to the cylinder deactivation system in the engine. The Engine Control Module (ECM) commands the cylinder deactivation system ON to deactivate engine cylinders 1, 7, 6, and 4, switching to a V4 mode.
Cylinder deactivation is accomplished by not allowing the intake and exhaust valves to open on the selected cylinders by using special valve lifters.
The P3443 code indicates that there is a low voltage in the cylinder 6 deactivation solenoid valve control circuit.
Switching between V8 and V4 modes is accomplished in less than 250 milliseconds, making the transitions seamless and transparent to the vehicle operator.
FAQ
If you’re experiencing the P3443 fault code, your engine light may be on. This could be due to low oil pressure, a restricted oil passage, a faulty valve lifter oil manifold assembly, an open or shorted valve lifter oil manifold assembly harness, a poor electrical connection in the valve lifter oil manifold assembly circuit, or a faulty engine control module (ECM). To fix the issue, check the possible causes listed above, visually inspect the related wiring harness and connectors, and look for damaged components or broken, bent, pushed out, or corroded connector pins.
If you’re experiencing the P3443 fault code, which is indicated by the engine light or service engine soon warning light turning on, there are a few possible causes. These include low oil pressure, a restricted oil passage, a faulty valve lifter oil manifold assembly, an open or shorted valve lifter oil manifold assembly harness, a poor electrical connection in the valve lifter oil manifold assembly circuit, or a faulty engine control module (ECM). To fix the issue, check the possible causes listed above, visually inspect the related wiring harness and connectors, and look for damaged components or broken, bent, pushed out, or corroded connector pins.
If you’re experiencing the P3443 automobile fault code, you may notice that your engine light is on. This could be caused by low oil pressure, a restricted oil passage, a faulty valve lifter oil manifold assembly, an open or shorted valve lifter oil manifold assembly harness, a poor electrical connection in the valve lifter oil manifold assembly circuit, or a faulty engine control module (ECM). To diagnose the issue, visually inspect the related wiring harness and connectors, checking for damaged components and broken, bent, pushed out, or corroded connector pins.
Wrap Up
If your engine light is on, it could be due to low oil pressure, restricted oil passage, or a faulty valve lifter oil manifold assembly. Check for damaged components and inspect the wiring harness and connectors. Don’t forget to look for broken, bent, pushed out, or corroded connector’s pins.