If you see the Engine Light ON or Service Engine Soon Warning Light, it could be due to the P2488 fault code. This code indicates a problem with the Exhaust Gas Temperature Sensor (EGTS) Bank 2 Sensor 5. The possible causes include a faulty sensor, open or shorted harness, poor electrical connection, exhaust leaks, or excessive particulate matter buildup on the sensor.
The repair importance is high as it can affect the engine’s performance and emissions. The repair difficulty is moderate, and it takes around 1.0 hour to fix.
To interpret the fault code, check the possible causes and visually inspect the related wiring harness and connectors for any damage or corrosion.
| Repair Importance Level | 6.67 (Out of 10) |
| Estimated Repair Time | Approximately 1.0 hour |
| Repair Difficulty Level | 6.67 (Out of 10) |
P2488: Unveiling The Symptoms Of This Auto Fault Code
If you notice the Engine Light ON or Service Engine Soon Warning Light, it could be a sign of p2488 fault code. Here are the symptoms to look out for:
- The P2488 fault code in automobiles can cause the following symptoms: Engine Light ON, Service Engine Soon Warning Light, decreased engine performance, engine stalling, rough idling, and decreased fuel efficiency.
- It can also cause issues with the vehicle’s cooling system, such as overheating or a malfunctioning fan.
- Additionally, the code may indicate a problem with the vehicle’s electrical system, such as a faulty sensor or wiring issue.
- It is important to address these symptoms promptly to prevent further damage to the vehicle and ensure safe driving conditions.
Decoding P2488: Common Causes Of The Fault Code
The automobile fault code p2488 can be caused by a range of issues, including a faulty sensor, poor electrical connection, exhaust leaks, and particulate buildup.
- The automobile fault code P2488 can be caused by a faulty Exhaust Gas Temperature Sensor (EGTS) Bank 2 Sensor 5.
- It can also be caused by an open or shorted Exhaust Gas Temperature Sensor Bank 2 Sensor 5 harness.
- A poor electrical connection in the Exhaust Gas Temperature Sensor Bank 2 Sensor 5 circuit can also trigger this fault code.
- Additionally, exhaust leaks and excessive particulate matter buildup on the sensor can cause the P2488 fault code.
Fix Code P2488: Simple Steps To Get Your Car Running
Below are the possible fixes for the automobile fault code p2488.
- To fix the automobile fault code p2488, first, check the possible causes listed above.
- Then, visually inspect the related wiring harness and connectors.
- Look for any damaged components and check for broken, bent, pushed out, or corroded connector’s pins.
- This fix will take an estimated repair time of 1.0 hour.
P2488: Affordable Fix For Your Car’s Fault Code
The automobile fault code P2488 can be diagnosed and fixed within an estimated repair time of 1.0 hour.
The cost of repair is influenced by the repair time, which is commonly charged between $75 and $150 per hour by most auto repair shops.
Therefore, the total cost of fixing the P2488 fault code will depend on the hourly rate charged by the repair shop and the estimated repair time required to fix the issue.
P2488: Your Car’s Cooling System Needs Attention
The P2488 code is related to the Exhaust Gas Temperature Sensor (EGTS).
The EGTS is responsible for detecting exhaust gas temperature and converting it into a voltage.
The PCM monitors the EGTS for proper circuit continuity and out of range high values.
The code is set when the EGTS is out of factory specifications. The EGTS is located in front of the Diesel Oxidation Catalyst (DOC) andor in front of the Diesel Particulate Filter (DPF).
The P2488 code specifically refers to the circuit rangeperformance of Bank 2 Sensor 5.
FAQ
If you see the engine light on or service engine soon warning light, it could be due to the P2488 fault code. This code is usually caused by a faulty Exhaust Gas Temperature Sensor (EGTS) Bank 2 Sensor 5, an open or shorted harness, poor electrical connection, exhaust leaks, or excessive particulate matter buildup on the sensor. To fix this issue, you should check the possible causes listed above, visually inspect the related wiring harness and connectors, and look for damaged components or broken, bent, pushed out, or corroded connector’s pins.
If you’re experiencing the P2488 fault code in your automobile, which is indicated by the Engine Light ON or Service Engine Soon Warning Light, it could be due to a faulty Exhaust Gas Temperature Sensor (EGTS) Bank 2 Sensor 5, an open or shorted Exhaust Gas Temperature Sensor Bank 2 Sensor 5 harness, a poor electrical connection in the Exhaust Gas Temperature Sensor Bank 2 Sensor 5 circuit, exhaust leaks, or excessive particulate matter buildup on the sensor. To fix this issue, you should visually inspect the related wiring harness and connectors, check for damaged components, and look for broken, bent, pushed out, or corroded connector’s pins.
If you see the Engine Light ON or Service Engine Soon Warning Light in your automobile, it could be due to the P2488 fault code. This code is caused by a faulty Exhaust Gas Temperature Sensor (EGTS) Bank 2 Sensor 5, open or shorted harness, poor electrical connection, exhaust leaks, or excessive particulate matter buildup on the sensor. To fix this issue, you should visually inspect the related wiring harness and connectors, check for damaged components, and look for broken, bent, pushed out, or corroded connector’s pins.
Wrap Up
If you see the Engine Light ON or Service Engine Soon Warning Light, it could be due to a faulty Exhaust Gas Temperature Sensor (EGTS) Bank 2 Sensor 5, exhaust leaks, or excessive particulate matter buildup on the sensor.
Check the wiring harness and connectors for damage and inspect the components for any issues.
