If you see the Engine Light ON or Service Engine Soon Warning Light, it could be due to the P2487 fault code. This code indicates a problem with the Exhaust Gas Temperature Sensor (EGTS) Bank 2 Sensor 5.
The possible causes include a faulty sensor, open or shorted harness, poor electrical connection, exhaust leaks, or excessive particulate matter buildup on the sensor.
The repair importance is high as it can affect the engine’s performance and emissions. The repair difficulty is moderate, and the fix involves visually inspecting the wiring harness and connectors, checking for damaged components, and looking for broken, bent, pushed out, or corroded connector’s pins. The repair time is estimated at 1.0 hour.
To interpret the fault code, you need an OBD-II scanner that can read and display the code.
| Repair Importance Level | 6.67 (Out of 10) |
| Estimated Repair Time | Approximately 1.0 hour |
| Repair Difficulty Level | 6.67 (Out of 10) |
P2487: Unveiling The Symptoms Of This Auto Fault Code
If you notice the Engine Light ON (or Service Engine Soon Warning Light), it could be a sign of p2487 fault code.
Here are the symptoms to look out for:
- The P2487 fault code in automobiles can cause several symptoms, including the engine light turning on or the service engine soon warning light appearing.
- Other symptoms may include reduced engine power, decreased fuel efficiency, and rough idling.
- Additionally, the vehicle may experience difficulty starting or may stall while driving.
- It is important to address these symptoms promptly to prevent further damage to the vehicle.
Decoding P2487: Common Causes Of The Fault Code
The automobile fault code P2487 can be caused by a range of issues, including faulty sensors, electrical problems, exhaust leaks, and particulate buildup.
- The automobile fault code P2487 can be caused by a faulty Exhaust Gas Temperature Sensor (EGTS) Bank 2 Sensor 5.
- It can also be caused by an open or shorted Exhaust Gas Temperature Sensor Bank 2 Sensor 5 harness.
- A poor electrical connection in the Exhaust Gas Temperature Sensor Bank 2 Sensor 5 circuit can also trigger this fault code.
- Additionally, exhaust leaks and excessive particulate matter buildup on the sensor can cause the P2487 fault code.
Fix Code P2487: Simple Steps To Get Your Car Running
Below are some possible fixes for the automobile fault code p2487, including inspecting wiring harness and connectors for damage or corrosion.
- To fix the automobile fault code p2487, you need to check the possible causes listed above.
- Visually inspect the related wiring harness and connectors.
- Look for damaged components and check for broken, bent, pushed out, or corroded connector’s pins.
- This fix will take an estimated repair time of 1.0 hour.
P2487: Affordable Fix For Your Car’s Fault Code
The automobile fault code P2487 can be diagnosed and fixed within an estimated repair time of 1.0 hour. The cost of repair is influenced by the repair time, which is commonly charged between $75 and $150 per hour by most auto repair shops.
Therefore, the total cost of fixing the P2487 fault code will depend on the hourly rate charged by the repair shop and the estimated repair time required to fix the issue.
P2487: Your Car’s Cooling System Needs Attention
The P2487 code is related to the Exhaust Gas Temperature Sensor (EGTS) circuit.
The EGTS is responsible for detecting exhaust gas temperature and converting it into a voltage signal. The PCM monitors the EGTS for proper circuit continuity and out of range high values. If the EGTS is out of factory specifications, the PCM sets the P2487 OBDII code.
This code specifically refers to Bank 2 Sensor 5.
FAQ
If you see the engine light on or service engine soon warning light, it could be due to the P2487 fault code. This code is usually caused by a faulty Exhaust Gas Temperature Sensor (EGTS) Bank 2 Sensor 5, an open or shorted harness, poor electrical connection, exhaust leaks, or excessive particulate matter buildup on the sensor. To fix this issue, you should check the possible causes listed above, visually inspect the related wiring harness and connectors, and look for damaged components or broken, bent, pushed out, or corroded connector’s pins.
If you’re experiencing the P2487 fault code in your automobile, which is indicated by the Engine Light ON or Service Engine Soon Warning Light, it could be due to a faulty Exhaust Gas Temperature Sensor (EGTS) Bank 2 Sensor 5, an open or shorted Exhaust Gas Temperature Sensor Bank 2 Sensor 5 harness, a poor electrical connection in the Exhaust Gas Temperature Sensor Bank 2 Sensor 5 circuit, exhaust leaks, or excessive particulate matter buildup on the sensor. To fix this issue, you should visually inspect the related wiring harness and connectors, check for damaged components, and look for broken, bent, pushed out, or corroded connector’s pins.
If you’re troubleshooting the P2487 fault code, start by checking for an illuminated Engine Light or Service Engine Soon Warning Light. The cause of this issue could be a faulty Exhaust Gas Temperature Sensor (EGTS) Bank 2 Sensor 5, an open or shorted harness, poor electrical connection, exhaust leaks, or excessive particulate matter buildup on the sensor. To fix the issue, visually inspect the related wiring harness and connectors, checking for damaged components and broken, bent, pushed out, or corroded connector pins.
Wrap Up
If you see the Engine Light ON or Service Engine Soon Warning Light, it could be due to a faulty Exhaust Gas Temperature Sensor (EGTS) Bank 2 Sensor 5, exhaust leaks, or excessive particulate matter buildup on the sensor. Check the wiring harness and connectors for damage and inspect the components for any issues.
