If you see the Engine Light ON or Service Engine Soon Warning Light, it could be due to the P2485 fault code. This code indicates a problem with the Exhaust Gas Temperature Sensor (EGTS) Bank 2 Sensor 5. The possible causes include a faulty sensor, open or shorted harness, poor electrical connection, exhaust leaks, or excessive particulate matter buildup on the sensor.
The repair importance is moderate, and the difficulty level is low.
To fix the issue, you need to visually inspect the wiring harness and connectors, check for damaged components, and look for broken, bent, pushed out, or corroded connector’s pins.
The repair time is around 1.0 hour. It’s essential to interpret the fault code correctly to avoid any further damage to your vehicle.
| Repair Importance Level | 6.67 (Out of 10) |
| Estimated Repair Time | Approximately 1.0 hour |
| Repair Difficulty Level | 6.67 (Out of 10) |
P2485: Unveiling The Symptoms Of This Auto Fault Code
If you notice the Engine Light ON or Service Engine Soon Warning Light, it could be a sign of p2485 fault code.
Here are the symptoms to look out for:
- The P2485 fault code in automobiles can cause the following symptoms: Engine Light ON, Service Engine Soon Warning Light, issues with the cooling fan, overheating of the engine, reduced fuel efficiency, and poor engine performance.
- It is important to address these symptoms promptly to avoid further damage to the vehicle.
P2485: Unveiling The Culprits Behind The Fault Code
The automobile fault code p2485 can be caused by a range of issues, including faulty sensors, electrical problems, exhaust leaks, and particulate buildup.
- The automobile fault code P2485 can be caused by a faulty Exhaust Gas Temperature Sensor (EGTS) Bank 2 Sensor 5.
- It can also be caused by an open or shorted Exhaust Gas Temperature Sensor Bank 2 Sensor 5 harness.
- A poor electrical connection in the Exhaust Gas Temperature Sensor Bank 2 Sensor 5 circuit can also trigger this fault code.
- Additionally, exhaust leaks and excessive particulate matter buildup on the sensor can cause the P2485 fault code.
Fix Code P2485: Simple Steps To Get Your Car Running
Below are the possible fixes for the automobile fault code p2485, including a visual inspection of related wiring harness and connectors.
- To fix the automobile fault code p2485, you need to check the possible causes listed above.
- Visually inspect the related wiring harness and connectors.
- Look for damaged components and check for broken, bent, pushed out, or corroded connector’s pins.
- This fix will take an estimated repair time of 1.0 hour.
P2485: Affordable Fix For Your Car’s Fault Code
The automobile fault code P2485 can be diagnosed and fixed within an estimated repair time of 1.0 hour. The cost of repair is influenced by the hourly rate charged by the auto repair shop, which typically ranges between $75 and $150 per hour.
Therefore, the total cost of diagnosis and fixing the P2485 fault code will depend on the hourly rate charged by the auto repair shop and the estimated repair time.
P2485: Your Car’s Cooling Fan Is In Trouble
The P2485 code is related to the Exhaust Gas Temperature Sensor (EGTS).
The EGTS detects exhaust gas temperature and converts it into a voltage. The PCM monitors the EGTS for proper circuit continuity and out of range high values. The code is set when the EGTS is out of factory specifications.
It is specifically related to the circuitopen bank 2 S of the sensor.
This fault code can cause increased emissions and may affect engine performance.
FAQ
If you see the engine light on or service engine soon warning light, it could be due to the P2485 fault code. This code is usually caused by a faulty Exhaust Gas Temperature Sensor (EGTS) Bank 2 Sensor 5, an open or shorted harness, poor electrical connection, exhaust leaks, or excessive particulate matter buildup on the sensor. To fix this issue, you should check the possible causes listed above, visually inspect the related wiring harness and connectors, and look for damaged components or broken, bent, pushed out, or corroded connector’s pins.
If you’re experiencing the P2485 fault code in your automobile, which is indicated by the Engine Light ON or Service Engine Soon Warning Light, it could be due to a faulty Exhaust Gas Temperature Sensor (EGTS) Bank 2 Sensor 5, an open or shorted Exhaust Gas Temperature Sensor Bank 2 Sensor 5 harness, a poor electrical connection in the Exhaust Gas Temperature Sensor Bank 2 Sensor 5 circuit, exhaust leaks, or excessive particulate matter buildup on the sensor. To fix this issue, you should visually inspect the related wiring harness and connectors, check for damaged components, and look for broken, bent, pushed out, or corroded connector’s pins.
If the P2485 fault code appears in your automobile, the engine light or service engine soon warning light will turn on. This is caused by a faulty Exhaust Gas Temperature Sensor (EGTS) Bank 2 Sensor 5, an open or shorted harness, poor electrical connection, exhaust leaks, or excessive particulate matter buildup on the sensor. To fix this issue, inspect the wiring harness and connectors for damage, broken, bent, pushed out, or corroded pins. Check the possible causes listed above.
Wrap Up
If you see the Engine Light ON or Service Engine Soon Warning Light, it could be due to a faulty Exhaust Gas Temperature Sensor (EGTS) Bank 2 Sensor 5, exhaust leaks, or excessive particulate matter buildup on the sensor.
Check the wiring harness and connectors for damage and inspect the components for any issues.
