The P2158 fault code in automobiles indicates a problem with the Vehicle Speed Sensor (VSS). The most common symptom is the illumination of the Engine Light or Service Engine Soon Warning Light. The cause of this fault code could be a faulty VSS, an open or shorted VSS harness, or a poor electrical connection in the VSS circuit.

The repair importance is high as it affects the vehicle’s speedometer and transmission shifting. The difficulty level of the repair is moderate, and it takes approximately 1.0 hour to fix.

To fix the issue, one should visually inspect the related wiring harness and connectors and check for damaged components.

Repair Importance Level10.0 (Out of 10)
Estimated Repair TimeApproximately 1.0 hour
Repair Difficulty Level10.0 (Out of 10)

If you notice the Engine Light ON (or Service Engine Soon Warning Light), it could be due to the p2158 fault code.

Here are the symptoms to look out for:

  • The P2158 fault code in an automobile can cause several symptoms, including the engine light turning on or the service engine soon warning light appearing.
  • Other symptoms may include issues with the vehicle’s transmission, such as difficulty shifting gears or the transmission slipping.
  • The vehicle may also experience a decrease in fuel efficiency or a reduction in power.
  • Additionally, the vehicle may experience stalling or hesitation during acceleration, and the speedometer may not function properly.
  • It is important to address these symptoms promptly to prevent further damage to the vehicle.

The automobile fault code p2158 can be caused by a faulty VSS, open or shorted VSS harness, or poor electrical connection.

  • The automobile fault code P2158 can be caused by a faulty Vehicle Speed Sensor (VSS).
  • It can also be caused by an open or shorted Vehicle Speed Sensor (VSS) harness.
  • Additionally, a poor electrical connection in the Vehicle Speed Sensor (VSS) circuit can also trigger this fault code.

To fix the p2158 automobile fault code, check the possible causes and inspect related wiring harness and connectors for damage.

  • To fix the automobile fault code p2158, you need to check the possible causes listed above.
  • Visually inspect the related wiring harness and connectors.
  • Look for damaged components and check for broken, bent, pushed out, or corroded connector’s pins.
  • This fix will take an estimated repair time of 1.0 hour.

The automobile fault code P2158 indicates a problem with the vehicle’s speed sensor circuit. The estimated repair time for this issue is 1.0 hour. The cost of fixing this problem can vary depending on the auto repair shop, but it is common for them to charge between $75 and $150 per hour.

Other factors that may influence the cost include the severity of the issue, the type of vehicle, and the location of the repair shop.

The P2158 code refers to a problem with the Vehicle Speed Sensor (VSS).

The VSS provides information about the speed of the vehicle to the Engine Control Module (ECM). The sensor is located in the transfer case and produces AC voltage as the output shaft and internal gear rotate. The ECM uses this signal to determine shift timing and transfer case range.

If the P2158 code appears, it means there is an issue with the VSS and it needs to be addressed.

What are the possible causes of the automobile fault code P2158?

If you see the engine light on or the service engine soon warning light, it could be due to the P2158 fault code. This code is usually caused by a faulty Vehicle Speed Sensor (VSS), an open or shorted VSS harness, or a poor electrical connection in the VSS circuit. To fix this issue, you should visually inspect the related wiring harness and connectors, check for damaged components, and look for broken, bent, pushed out, or corroded connector’s pins.

How can I fix the P2158 fault code in my vehicle?

If you’re experiencing the P2158 fault code, which is indicated by the Engine Light ON or Service Engine Soon Warning Light, it could be due to a faulty Vehicle Speed Sensor (VSS), an open or shorted VSS harness, or a poor electrical connection in the VSS circuit. To fix this issue, you should visually inspect the related wiring harness and connectors, check for damaged components, and look for broken, bent, pushed out, or corroded connector’s pins.

Is it necessary to visually inspect the wiring harness and connectors to fix the P2158 fault code?

Yes, it is necessary to visually inspect the wiring harness and connectors to fix the P2158 fault code. The fault code is caused by a faulty Vehicle Speed Sensor (VSS), an open or shorted VSS harness, or poor electrical connection in the VSS circuit. To fix the issue, it is recommended to check the possible causes listed above and visually inspect the related wiring harness and connectors for any damage or corrosion. This will help identify any broken, bent, pushed out, or corroded connector’s pins that may be causing the fault code.

p2158 error fault code explained

If your engine light is on and you have a P2158 code, it’s likely due to a faulty Vehicle Speed Sensor (VSS), an open or shorted VSS harness, or a poor electrical connection.

To fix it, visually inspect the wiring harness and connectors for damage, broken, bent, pushed out, or corroded pins.

Scroll to Top