The P1E61 automobile fault code indicates a problem with the HybridElectric Vehicle Battery Pack or the Battery Interface Control Module. The most common symptom is the Engine Light turning on.
The importance of repairing this issue lies in the fact that it affects the performance of the vehicle and can lead to further damage. The repair difficulty is moderate, and it is recommended to visually inspect the wiring harness and connectors for any damage or corrosion.
The possible fix is to replace the faulty components.
The repair time is estimated to be around 1.0 hour.
It is crucial to interpret the fault code correctly to ensure the proper repair of the vehicle.
Repair Importance Level | 10.0 (Out of 10) |
Estimated Repair Time | Approximately 1.0 hour |
Repair Difficulty Level | 10.0 (Out of 10) |
P1E61: Uncovering The Symptoms Of This Auto Fault Code
If you notice the Engine Light ON (or Service Engine Soon Warning Light), it could be due to the p1e61 fault code.
Here are the symptoms to look out for:
- The P1E61 fault code in an automobile can cause several symptoms, including the engine light turning on or the service engine soon warning light appearing.
- Other symptoms may include reduced engine power, decreased fuel efficiency, and difficulty starting the engine.
- Additionally, the vehicle may experience rough idling or stalling, and there may be a noticeable decrease in acceleration.
- It is important to address these symptoms promptly to prevent further damage to the vehicle and ensure safe driving conditions.
Decoding P1E61: Common Causes Of This Fault Code
The P1E61 fault code can be caused by a faulty battery pack or battery interface control module in hybridelectric vehicles.
- The automobile fault code P1E61 can be caused by a faulty Hybrid/Electric Vehicle Battery Pack.
- It can also be caused by a faulty Hybrid/Electric Vehicle Battery Interface Control Module.
- These are the only two causes of the P1E61 fault code.
Fix Code P1E61: Simple Steps To Get Your Car Running
Below are the possible fixes for the automobile fault code p1e61, including inspecting wiring harness and connectors for damage or corrosion.
- To fix the automobile fault code P1E61, first, check the possible causes listed above.
- Then, visually inspect the related wiring harness and connectors.
- Look for damaged components and check for broken, bent, pushed out, or corroded connector’s pins.
- This fix will take an estimated repair time of 1.0 hour.
P1E61: Affordable Fix For Complex Automobile Fault Code
The factors that influence the cost of diagnosing and fixing the automobile fault code P1E61 are: – The estimated repair time is 1.0 hour. – Auto repair shops typically charge between $75 and $150 per hour. – The cost may vary depending on the location and reputation of the repair shop. – The cost may also depend on the severity of the issue and the parts that need to be replaced. – It is important to get a detailed estimate from the repair shop before proceeding with the repairs.
P1E61: Your Car’s Battery Needs Attention
The P1E61 fault code refers to a circuit issue in the HybridElectric Vehicle battery pack. The battery pack contains 288 cells grouped in parallel and connected in-series. The battery energy control module monitors the voltage of the 96 battery cell groups through the four hybridEV battery interface control modules.
The battery energy control module will determine when a fault condition is present and communicate it to the hybridEV powertrain control module 2 through serial data. The P1E61 code specifically indicates a problem with Battery 54 circuit. All components related to the battery energy control module, hybridEV battery interface control module, and battery control harness are serviceable.
FAQ
If you see the engine light on or the service engine soon warning light, it could be due to the P1E61 fault code. This code is caused by a faulty hybrid/electric vehicle battery pack or a faulty hybrid/electric vehicle battery interface control module. To fix this issue, you should check the possible causes listed above, visually inspect the related wiring harness and connectors, and look for damaged components or broken, bent, pushed out, or corroded connector’s pins.
If you’re experiencing the P1E61 fault code, which is indicated by the Engine Light ON or Service Engine Soon Warning Light, you may have a faulty Hybrid/Electric Vehicle Battery Pack or a faulty Hybrid/Electric Vehicle Battery Interface Control Module. To fix this issue, you should check the “Possible Causes” listed above and visually inspect the related wiring harness and connectors. Look for damaged components and check for broken, bent, pushed out, or corroded connector’s pins.
If you encounter damaged components or broken, bent, pushed out, or corroded connector’s pins while fixing the P1E61 fault code, follow these steps: Check the “Possible Causes” listed above, visually inspect the related wiring harness and connectors, and look for damaged components. It is important to check for broken, bent, pushed out, or corroded connector’s pins.
![p1e61 error fault code explained](https://carmodnerd.com/wp-content/uploads/2023/06/P1E61-error-fault-code.jpg)
Wrap Up
If your engine light is on, it could be due to a faulty hybridelectric vehicle battery pack or interface control module.
Check the possible causes, inspect wiring and connectors, and look for damaged components or corroded pins.