The P1E58 fault code in automobiles indicates a problem with the hybridelectric vehicle battery pack or the battery interface control module. The most common symptom is the illumination of the engine light or service engine soon warning light. The cause of this issue is often due to a faulty battery pack or control module.
To fix this problem, one should visually inspect the wiring harness and connectors for any damage or corrosion.
The repair time for this issue is estimated to be around 1.0. It is important to address this issue promptly to avoid further damage to the vehicle’s electrical system. To interpret the fault code, one should consult the vehicle’s manual or seek the assistance of a professional mechanic.
| Repair Importance Level | 10.0 (Out of 10) |
| Estimated Repair Time | Approximately 1.0 hour |
| Repair Difficulty Level | 10.0 (Out of 10) |
P1E58: Uncovering The Symptoms Of This Auto Fault Code
If you notice the Engine Light ON or Service Engine Soon Warning Light, it could be a sign of p1e58 fault code.
Here are the symptoms to look out for:
- The P1E58 fault code in automobiles can cause several symptoms, including the engine light turning on or the service engine soon warning light appearing.
- Other symptoms may include reduced engine power, decreased fuel efficiency, and difficulty starting the engine.
- Additionally, the vehicle may experience rough idling or stalling, and there may be a noticeable decrease in acceleration.
- It is important to address these symptoms promptly to prevent further damage to the vehicle and ensure safe driving conditions.
Decoding P1E58: Common Causes Of The Fault Code
P1E58 fault code can be caused by a faulty battery pack or battery interface control module in hybridelectric vehicles.
- The automobile fault code P1E58 can be caused by a faulty Hybrid/Electric Vehicle Battery Pack.
- It can also be caused by a faulty Hybrid/Electric Vehicle Battery Interface Control Module.
- These are the only two causes of the P1E58 fault code.
Fix Code P1E58: Simple Steps To Get Your Car Running
Below are some possible fixes for the automobile fault code p1e58, including inspecting wiring harness and connectors for damage or corrosion.
- To fix the automobile fault code p1e58, first, check the possible causes listed above.
- Then, visually inspect the related wiring harness and connectors.
- Look for damaged components and check for broken, bent, pushed out, or corroded connector’s pins.
- This fix will take an estimated repair time of 1.0 hour.
P1E58: Affordable Fix For Your Car
The factors that influence the cost of diagnosing and fixing the automobile fault code P1E58 are: – The estimated repair time is 1.0 hour.
– Auto repair shops typically charge between $75 and $150 per hour. – The cost may vary depending on the location and reputation of the repair shop. – The cost may also vary depending on the severity of the issue and the parts that need to be replaced.
– It is important to get a detailed estimate from the repair shop before proceeding with the repairs.
P1E58: Your Car’s Battery Is In Trouble
The P1E58 fault code is related to the HybridElectric Vehicle Battery 45 Circuit. The battery pack contains 288 cells grouped in parallel and series. The battery energy control module monitors the voltage of the 96 battery cell groups through the four hybridEV battery interface control modules.
The battery energy control module will determine when a fault condition is present and communicate it to the hybridEV powertrain control module 2 through serial data. The hybridEV powertrain control module 2 is the host controller for diagnostic trouble code information.
The battery sections and their components are individually serviceable.
FAQ
If you see the engine light on or the service engine soon warning light, it could be due to the P1E58 fault code. This code is caused by a faulty hybrid/electric vehicle battery pack or a faulty hybrid/electric vehicle battery interface control module. To fix this issue, you should visually inspect the related wiring harness and connectors, check for damaged components, and look for broken, bent, pushed out, or corroded connector’s pins.
If you’re experiencing the P1E58 fault code, which is indicated by the Engine Light ON or Service Engine Soon Warning Light, it could be caused by a faulty Hybrid/Electric Vehicle Battery Pack or a faulty Hybrid/Electric Vehicle Battery Interface Control Module. To fix this issue, you should check the possible causes listed above and visually inspect the related wiring harness and connectors. Look for damaged components and check for broken, bent, pushed out, or corroded connector’s pins.
Ignoring the P1E58 fault code, which indicates a faulty Hybrid/Electric Vehicle Battery Pack or Interface Control Module, can lead to serious consequences. The Engine Light or Service Engine Soon Warning Light will remain ON, indicating a problem with the vehicle. This can result in reduced fuel efficiency, decreased performance, and potential damage to other components. It is important to check the possible causes, visually inspect the wiring harness and connectors, and fix any damaged components to avoid further issues.
Wrap Up
If your engine light is on, it could be due to a faulty hybridelectric vehicle battery pack or interface control module. Check for damaged components and inspect the wiring harness and connectors for any issues.
Look for broken, bent, pushed out, or corroded connector’s pins to fix the problem.
