The P1B67 automobile fault code indicates a problem with the HybridElectric Vehicle Battery Pack or the Battery Interface Control Module. The most common symptom is the Engine Light turning on. The cause of this issue is a faulty battery pack or control module.
It is important to address this issue promptly as it can lead to reduced fuel efficiency and performance.
The repair difficulty is moderate, and it takes approximately 1.0 hour to fix.
To diagnose the problem, one should visually inspect the wiring harness and connectors for any damage or corrosion. The possible fix is to replace the damaged components and repair any broken or bent pins.
| Repair Importance Level | 10.0 (Out of 10) |
| Estimated Repair Time | Approximately 1.0 hour |
| Repair Difficulty Level | 10.0 (Out of 10) |
P1B67: Uncovering The Symptoms Of This Auto Fault Code
If you notice the Engine Light ON or Service Engine Soon Warning Light, it could be a sign of p1b67 fault code. Here are the symptoms to look out for:
- The P1B67 fault code in an automobile can cause several symptoms, including the engine light turning on or the service engine soon warning light appearing.
- Other symptoms may include issues with the vehicle’s acceleration, a decrease in fuel efficiency, and problems with the transmission shifting smoothly.
- Additionally, the vehicle may experience stalling or hesitation when attempting to accelerate, and there may be a noticeable decrease in power while driving.
- It is important to address these symptoms promptly to prevent further damage to the vehicle.
Decoding P1B67: Common Causes Of Fault Code
P1B67 fault code can be caused by a faulty battery pack or battery interface control module in hybridelectric vehicles.
- The automobile fault code P1B67 can be caused by a faulty Hybrid/Electric Vehicle Battery Pack.
- It can also be caused by a faulty Hybrid/Electric Vehicle Battery Interface Control Module.
- These are the only two causes of this particular fault code.
Fix Code P1B67: Simple Steps To Get Your Car Running
Below are the possible fixes for the automobile fault code p1b67, including inspecting wiring harness and connectors for damage or corrosion.
- To fix the automobile fault code P1B67, you need to check the possible causes listed above.
- Visually inspect the related wiring harness and connectors for any damage.
- Look for broken, bent, pushed out, or corroded connector’s pins.
- This fix will take an estimated repair time of 1.0 hour.
Crunching The Numbers: P1B67 Fixing Cost & Complexity
The automobile fault code P1B67 has an estimated repair time of 1.0 hour. The cost of fixing this fault code varies depending on the auto repair shop, but it is common for most shops to charge between $75 and $150 per hour.
Therefore, the total cost of fixing this fault code will depend on the hourly rate charged by the auto repair shop and the estimated repair time.
These factors should be considered when diagnosing and fixing the P1B67 fault code.
P1B67: The Low Voltage Battery Charge System – Explained
The P1B67 code is related to the HybridElectric Vehicle battery pack. The battery pack contains 288 cells grouped in parallel and series.
There are three battery sections, each with a different number of cells and cell groups. The battery energy control module monitors the voltage of the 96 battery cell groups through the hybridEV battery interface control modules. The battery energy control module will determine when a fault condition is present and communicate it to the hybridEV powertrain control module 2.
The P1B67 code indicates a low voltage in the HybridElectric Vehicle Battery 44 Circuit.
FAQ
If you see the engine light on or the service engine soon warning light, it could be due to the P1B67 fault code. This code is usually caused by a faulty hybrid/electric vehicle battery pack or a faulty hybrid/electric vehicle battery interface control module. To fix this issue, you should visually inspect the related wiring harness and connectors, check for damaged components, and look for broken, bent, pushed out, or corroded connector’s pins.
If you’re experiencing the P1B67 fault code, which is indicated by the Engine Light ON or Service Engine Soon Warning Light, you may have a faulty Hybrid/Electric Vehicle Battery Pack or a faulty Hybrid/Electric Vehicle Battery Interface Control Module. To fix this issue, you should check the possible causes listed above and visually inspect the related wiring harness and connectors. Look for damaged components and check for broken, bent, pushed out, or corroded connector’s pins.
If you’re fixing the P1B67 fault code, you should look for signs of damaged components and broken, bent, pushed out, or corroded connector’s pins. These issues can cause the engine light to turn on or trigger the service engine soon warning light. To fix the problem, visually inspect the related wiring harness and connectors, and check for the possible causes listed above.
Wrap Up
If your engine light is on, it could be due to a faulty hybridelectric vehicle battery pack or interface control module. Check the possible causes, inspect wiring and connectors, and look for damaged components or corroded pins.
